View Full Version : Door opener needed
Inam building a new effect and need something that will open and close a small metal door (it's an electrical panel). I would rather not have to run air but can if needed.
03-20-2012, 08:09 PM
does it need to be on a timer to go at specific times? or constantly opening and closing. check out these motors
Actually the armature is the critical piece I am looking for. I want the door to pop open when triggered. I was thinking something pneumatic or air driven but electric is good as well. Door is small; electrical panel.
04-02-2012, 10:37 AM
if you just want to open it a little bit i would advise using the electric motor and rig it up on a motion/ mat sensor. If you want it to open all the way than you could use a small cylinder and hook it up with air. ( if it were me i would use the motor because it would be a little cheaper and you don't have to rig up the air)
04-02-2012, 07:25 PM
You might want to look into an electric car door opener. They run on 12 volts DC and cost about $10 (maybe cheaper if you pull them yourself at a junk yard). Then all you need to do is use a spring to either hold the door open or closed and use the actuator to move the door. Just another option to explore...
06-07-2012, 08:10 PM
You can use a 12 volt wiper motor. There will be wire for 12 volt positive and ground, High and Low, and a "park". If your prop was wired into the park wire, the motor operates once and shuts off.
I'm not sure about the other motors sold out there.
07-12-2012, 09:27 PM
Here's how I did mine using a 12V vent motor - http://www.youtube.com/watch?v=DCNL0n1CkJk&list=UUKKBTwYyVYxkpa0_9pqQ13A&index=7&feature=plcp
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.