Controlling a fog machine from a PicoBoo
Oh no! Sorry to hear this. The PicoBoo only acts as a switch touching the two wires together. It does not send voltage to the device or anything like that.
Here is our tech doc on controlling a fog machine from a PicoBoo
If your manual remote looks different or you can't find where to hook into the button:
If you have a multimeter (or continuity tester) put it into continuity test mode. When the two leads are touched together it will beep.
Remove power from the fog machine and touch one lead to one of the wires on the fog machine's manual push button and the other to another wire. Push the button in. If you hear a beep then you have found the two wires you need to tap into. If you do not hear a beep then move the leads to different set of wires and try again. Once you have the two wires identified solder to them and install one into "C" and the other into "N/O" on the PicoBoo controller. Program the PicoBoo to activate the fog machine.
If you do not have a continuity tester maybe send me a picture of the underside of the button where the wires are and I can see if I can figure out the wires.