Announcement

Collapse
No announcement yet.

Barbed wire

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Barbed wire

    Hello all, I'm pretty new around here hope to get some feedback on some ideas I've had...

    For starters here's a little gem I stumbled upon when wiring my barn for sound. It started with a roll if speaker wire, (I don't remember what the size was) and a pair of scissors. I cut the wire into a strip approximately 5ft, I put one end in my vice, and the other in the bit of my drill. I twisted the wire until it looked like this.

    twist.JPG

    I then cut multiple sections of speaker wire form the roll about three inches long, I then peeled apart the wire.

    splitwire.JPG

    I then wrapped the peeled wire around the twisted wire and tied it with a simple knot. I also trimmed the edges off to the appropriate length at and angle just to give it that barbed look.

    wrapknot.JPG

    after that I hung it up and hit it with some Osh silver spray paint, and VOILA! you have perfectly harmless barbed wire... We use this in a scene where we have one of our actors tied down to a chair in a dark room (for developing film).

    DSC01382.JPGDSC01392.JPG


    Let me know what you think,

    Frightmare Farms

  • #2
    This is very cool!

    Comment


    • #3
      Looks good. You can also use cut up rubber bands for the barbs.

      Comment

      Working...
      X